Hello guest! Are you an Apistogramma enthusiast? If so we invite you to join our community and see what it has to offer. Our site is specifically designed for you and it's a great place for Apisto enthusiasts to meet online. Once you join you'll be able to post messages, upload pictures of your fish and tanks and have a great time with other Apisto enthusiasts. Sign up today!
Not that trade what I ment was someone who is a bio-chemist and would be interested in this reserch.
Have used peat for years as I keep killifish but I use peat blocks and do top-ups with the water that it`s soaked in. After all apisto`s and killies use much the same type of water just the temp is raised for apistos.
Just get the blocks from up north where peat is used as fuel.
Me too, using water soaked in peat in advance for water change. But do you run an air pump in this aged water to circulate it? Or do you just leave it stagnant with the peat inside.
Just run a few airlines off my blower into a 45 gall drum, as I use peat blocks there is no chance of peat floating about in the water as the blocks don`t break up, finish up with peat stained water.
This topic is very informative.
I have been wondering. Does peat start to release pH increasing or buffering agents once it has given all the H it can?
I have a problem with keeping my pH down, i use water which has pH 6.5 and KH 1.5 for every water change. And a day after my pH goes to 7.0 in my tank. It wont come down even if i add HCl to the tank. The tanks KH is 1.5 as well.
I am wondering if the peat i use and the peat in put in the gravel has a pH increasing effect after long use.
Well,
My gravel is aquaclay, and the filter material i use are from Eheim and are supposed to be safe too...
Aquaclay is similar to ADAs aquasoil.. Its the red version and doesn't go into reaction with HCl. Same applies for Eheims filter material.
Other than these i only have driftwood and peat and coconut shells ..
The aquaclay was mixed with a white stone when i bought it, which i found to be effecting the pH and i cleaned it all..Except maybe for very tiny pieces but then again the hardness of the water does not increase as you would expect when rock effect the pH.
I suspect that your Aquaclay still has tiny carbonate particles in it. These will buffer the pH faster than the raise the hardness. I suggest trying your treated water in a bare tank or tank with silica sand. If the pH does not bounce up, then you know it is the Aquaclay.
You answer your own question there in saying that when you have water in a bucket the pH stays steady, and as Mike says you must have a source of carbonate in the Aquaclay, this is forcing the pH up , the best solution would be to change your substrate for another type; Silica Sand for example.
Sorry for hijacking the thread and thanks for the answers.
I have set up an experiment which will test the theory.
I have prepared a solution pH2.5 and divided into 2 glasses. In one i will leave it as is in other i fill add a spoon of aquaclay. Lets see what comes of it..
Silica sand is quite difficult to wash isn't it? Especially in winter
I don't know the sources for sand in your country, but silica sand is sold pre-washed for aquariums in the US. If you are not using undergravel filter plates, the sand does not need to be cleaned as much.
The blank test glass pH2.5 like last night,
The glass with aquaclay from tank is 2.7.. So it must be the gravel after all. Wil look for a replacement this weekend..